How hard is the water in Chilton County, AL?

1.3 grains per gallon

You do not need a softener here.

The median hardness measured in Chilton County, AL is 21 mg/L as calcium carbonate, which is 1.3 gpg. That is soft on the USGS scale. It comes from 361 samples at 30 sites between 1993 and 2026, drawn from every sampling site in the county, wells and surface water together.

How much it varies here

Half the sites came in between 0.6 and 2.8 gpg. The whole middle of that range gives the same answer, so a test of your own tap is unlikely to change it. Confidence in the county figure: high (how it is measured).

What to do next

You can skip the softener. At 1.3 gpg the most a softener would fix is the odd water spot. If a salesperson in Chilton County says otherwise, ask to see their reading in grains per gallon and compare it with this one.

More on when a softener is not worth it.

From 0.2 to 4.8 gpg

The softest single sample on record in Chilton County was 2.8 mg/L and the hardest 81.6 mg/L, a 29-fold gap. The top quarter of sites read above 2.8 gpg and the bottom quarter below 0.6 gpg.

Wells 1.4 gpg, rivers and lakes 1.3 gpg

5 groundwater samples from 4 wells put the median at 24.4 mg/L. 356 surface samples from 26 sites put it at 21.4 mg/L. In Chilton County the wells come out 0.1 gpg harder. Groundwater sits in contact with rock for years and picks up calcium and magnesium as it goes, so wells usually read harder. The two sources are close, so the county figure should hold whichever one your tap is on.

Chilton County against the rest of Alabama

Among the 67 Alabama counties with data, Chilton County is number 49 of 67 counting from the hardest. Across the whole country it is harder than 9% of counties.

Softest in Alabama: Washington County at 0.2 gpg. Hardest: Walker County at 13.1 gpg. Closest to Chilton County: Russell County (1.2), Henry County (1.2), Elmore County (1.3).