How hard is the water in Alleghany County, NC?

1.2 grains per gallon

You do not need a softener here.

The median hardness measured in Alleghany County, NC is 21 mg/L as calcium carbonate, which is 1.2 gpg. That is soft on the USGS scale. It comes from 239 samples at 14 sites between 1990 and 2025, drawn from every sampling site in the county, wells and surface water together.

How much it varies here

Half the sites came in between 1 and 1.6 gpg. The whole middle of that range gives the same answer, so a test of your own tap is unlikely to change it. Confidence in the county figure: high (how it is measured).

What to do next

You can skip the softener. At 1.2 gpg the most a softener would fix is the odd water spot. If a salesperson in Alleghany County says otherwise, ask to see their reading in grains per gallon and compare it with this one.

More on when a softener is not worth it.

From 0.5 to 3.6 gpg

The softest single sample on record in Alleghany County was 9.1 mg/L and the hardest 61.8 mg/L, a 7-fold gap. The top quarter of sites read above 1.6 gpg and the bottom quarter below 1 gpg.

Wells 2.2 gpg, rivers and lakes 1.1 gpg

4 groundwater samples from 4 wells put the median at 37.8 mg/L. 235 surface samples from 10 sites put it at 18 mg/L. In Alleghany County the wells come out 1.1 gpg harder. Groundwater sits in contact with rock for years and picks up calcium and magnesium as it goes, so wells usually read harder. The two sources are close, so the county figure should hold whichever one your tap is on.

Alleghany County against the rest of North Carolina

Among the 99 North Carolina counties with data, Alleghany County is number 68 of 99 counting from the hardest. Across the whole country it is harder than 9% of counties.

Softest in North Carolina: Bertie County at 0.3 gpg. Hardest: Dare County at 63.7 gpg. Closest to Alleghany County: Stokes County (1.2), Cleveland County (1.2), Scotland County (1.1).